现浇隔离墩模具使用方法与说明主要是按照相对应的步骤而言，一般防撞隔离墩模具在使用之前，先要将所需要的螺丝搭配好，然后按照模具大小匹配相对应的振动棒，而且在脱模时间上也要根据模具大小。以下就是现浇隔离墩模具使用程序中的一些事项：使用之前必须要检查防撞隔离墩模具的外边有无凹凸痕迹，如果有的话，已经不能在使用了；使用之前必须保证螺丝是否拧紧，如果没有拧紧就灌泥的话会是水泥流出，浪费材料，损害模具本身；在刷油的时候，一定要在内部全方面的刷均匀，不然在脱模的时候是会很困难的；在灌泥的时候一定要整栋，不然成品制作出来是不均匀的而且也有很多气泡，质量十分的差；灌泥结束后一定要放在平整的地面上，不然出来的成品可能会倾斜，这样制作出来的就是废品了，在道路上根本站不住。The use methods and instructions of cast-in-place isolation pier mold are mainly based on the steps corresponding to the photography. Generally, before using the anti-collision isolation pier mold, the required screws should be matched well, and then the corresponding vibrator should be matched according to the mold size, and the demoulding time should also be based on the mold size. The following are some matters in the use procedure of cast-in-place isolation pier mould: before use, it is necessary to check whether there are concave and convex marks on the outer edge of the anti-collision isolation pier mould, if any, it can not be used; before use, it must be ensured whether the screws are tightened, if not, it will be cement outflow, waste of materials, damage the mould itself; when painting oil, the first It must be brushed evenly in all aspects of the interior, otherwise it will be very difficult to demould; the whole building must be filled with mud, otherwise the finished product is not even and there are many bubbles, the quality is very poor; the finished product must be placed on the flat ground after the mud pouring, otherwise the finished product may incline, so the finished product is the waste product, which is on the road I can't stand it at all.